Pag. 4
English
COMPONENTS:
A Safety cap
B on/off boiler switch
C Steam switch
D Steam hose socket
E Low water red indicator light
G Power cord with plug
H Steam regulator knob
M Pressure gauge
USER INSTRUCTIONS:
1.
Remove the machine from its packing and make sure all the packing parts have been taken
off (including the protection bags).
2.
Lay the machine on a flat and steady surface next to a wall socket (max.1,5 Mt.).
3.
Unscrew the safety cap (A) and fill the tank with max 2,0. Make sure that the water does not
overspill. Screw the cap (A).
4.
Connect the plug to the main supply point.
5.
Push the boiler switch (B) which will come on to confirm the machine is plugged in
6.
Wait until the boiler switch (B) and steam switch (C) go off. The steam is ready and the gauge
(M) displays the pressure level (max. about 3,5 - 4 bar)
7.
Insert the steam hose plug (GV520) into the proper socket (D); push the plug into the socket until it
clicks. The steam hose is supplied with a handle to attach the brush or other accessories.
CAUTION:
make sure that it was correctly attached (risk of scalds).
8.
After attaching one of the brushes or an accessory onto the handle, regulate the steam through
the steam knob (H). To make the steam flow out, press the steam switch (C) first, it will comes
on, then the button (0-1) in the inside of the steam hose handle (GV520). You may get the best
performance by spray the steam on a cloth until the steam flows uniformly.
9.
Remove the brush/accessory by pushing the red button and take it off.
Caution: before
taking the brush/accessory off make sure the steam switch (C) is off.
10.
When the water tank is almost empty, the low water indicator light (E) will comes on. Before
filling the tank again, make sure that there is no emission of steam from the brush and the plug
(E) is disconnected
11.
At the first request of steam, after switching it on, there might be a drop of pressure caused by
the internal hoses’ filling. Wait for some minutes that the switch (B) is off.
TECHNICAL DATA:
Boiler power: 1400 watt
Working pressure: 3,5 bar
Max. pressure: 5,5 bar
Nominal tank capacity: 2,5 litres
CAUTION:
-
Never leave the machine unattended when it is plugged in
-
Disconnect the plug from main supply point before filling the tank
-
For complete safety never remove the safety cap while the machine is running and before
removing it, make sure there is no emission of steam from the brush.
-
Replaced the supplied thermal-stop device by authorized technicians only, or contact one of
our Service Center
-
Replaced the safety cap with original spare parts only.
-
Contact our Service Center for any repairs.
MAINTENANCE:
To get the best performance use tap water only.
Clean the tank periodically (each 15-20 litre water) by rinsing it with tap water.
