MANUAL LEKKER BIKES / Amsterdam M2 Series
5
MANUAL LEKKER BIKES / Amsterdam M2 Series
6
CHAPTER 1
1. Congratulations!
You are the proud owner of a
brand new
Amsterdam M2
! When you receive your
bike, the first thing to do is check that it has arrived
in perfect condition, Open the top of the box, and
visually inspect the bike.
2.
Remove the bike from the box, some help may be
needed for this step (you may find it easier to
cut
the side
of the box open and use this as a
surface
to build on, be careful whilst using sharp knives!).
Once removed, you will find a small
accessory box.
3.
For the correct assembly of your bike you will
need the following tools;
8mm/10mm/15mm
spanners
,
3/4/5/6mm Allen keys
, a small amount
of lithium
grease
and a
pump
.
Getting started
CHAPTER 2
Handlebar fitment and
adjustment
4.
Remove all the packaging,
cut
the cable ties holding the
handlebars
and
front wheel.
Carefully remove the
front wheel
,
you may need to
spin
the
pedal arm
to help give it
space
, be
careful not to force it and damage spokes or the wheel. Leave the
rear wheel in the cardboard for stability and place a piece of foam
on the top bar to
avoid scratches
while assembling. Remove the
small plastic
tab from between the brake pads and loosen the
axle nuts.
5.
In the box, you’ll find
information
about the brakes and belt
system, pedals, small rubber plug, and spare brake tabs (these
can be used while traveling with your bike with the wheels
removed).
6.
Using a
4mm
allen key, undo the
4 bolts
located on the front of
the stem, then place the
handlebars
in the stem and gently
tighten each bolt, ensuring they are done so evenly. Centre and
adjust the angle of the handlebar, once you have found your
desired bar angle, tighten the bolts to
5Nm
importantly making
sure they are
tightened evenly.
