MANUAL LEKKER BIKES / Amsterdam M2 Series
17
MANUAL LEKKER BIKES / Amsterdam M2 Series
18
CHAPTER 4
IMAGES
Chapter 4
Assembly of the pedals
13.
For the assembly of the pedals you will need a
15mm
open-ended
spanner.
ATTENTION:
please make sure to check the
thread direction
before inserting the pedals, as fitting the pedal to the wrong side can
damage the crank arm which is not covered under warranty! If the pedal
has ridges where you tighten with a spanner
14. Flip
the bike back over. Apply some grease or anti seize to the
threads and tighten to
40-42Nm torque
.
PLEASE NOTE;
It is very
important to tighten the pedals to the correct torque, as by not doing so
will lead to the pedals
loosening and damaging
the crank arm thread,
which is
not covered
under warranty!
15.
To install the
saddle
, use a
5mm
allen key. Apply a small amount of
grease to the inside of the frame tube. Now insert the saddle to the
desired height and tighten using the key. You can adjust the angle of the
saddle using a
6mm
allen key under the saddle.
16.
You can now
adjust
the angle of the
brake levers
and
gear shifter
if
you wish. Using a
5mm
Allen key, loosen the bolt on each of the brake
levers to allow you to move them, once in the correct position
tighten
the bolts to the manufacturer’s torque recommendation,
PLEASE NOTE:
you may have to
adjust
the gear shifter position to allow you to move the
right hand lever, to do this,
loosen
the bolt with a
3mm
allen key, then
perform the same steps as above, just remember to
tighten
the shifter
back up!
13
14
15
15.1
