LEITZ EasyLaminator A4, Operating Instructions Manual

Page: 4 / 31

4
English
Safety instructions and preconditions
for use
This unit has been designed for laminating paper or similar
materials with a maximum thickness of 1mm (including lami-
nation film). Use it for this purpose only and as described in
these operating instructions.
•
Before first use: Remove the cutter transport protection
at the rear of the unit.
•
If children and juveniles are using the unit: Removal of
faults (e.g. film jam) is only allowed by adults or under
adults’ supervision. The same applies to servicing
(changing cartridge or cutter).
•
Protect the environment: Hand in used film and car-
tridges for recycling.
•
Only use original LEITZ by XYRON accessories.
•
Keep the operating instructions with the unit at all times.
Helpul hints
•
To ensure a straight lamination always guide your docu-
ment with one hand while turning the handle clockwise.
•
Laminate small items side by side to take full advantage
of the lamination film’s width.
•
When the end-of-roll-marker appears, approximately
45cm of film is left. You can remove the marker easily by
peeling it off.
•
You can also trim your laminated document right to the
edge without the film coming off. However, such a docu-
ment is no longer protected safely against fluid.
With a few simple steps you’ll enhance documents like busi-
ness cards, photos, certificates, presentations, name signs
and much more:
1. Preparing the laminator
•
Place the laminator on a stable, flat surface (e.g.
table).
•
Ensure there is enough space behind the unit for the
laminated material.
•
Pull up and fold down the tray.
2. Laminating
Important:
Lamination is permanent. Before laminating individ-
ual pieces, test the process with a similar item.
•
Align your document to the left side and insert it into
the laminator as far as it will go.
• Slowly
turn the handle clockwise until the document is
caught and completely put out at the rear side.
3. Trimming the laminated document
•
To trim the laminated document, press down the cutter
and slide it from one side to the other.
A. Transporting and storing the laminator
•
Fold up the tray.
•
The laminator can be easily transported or put away
with one hand.
B. Replacing the lamination cartridge
•
Open the lid.
•
Take out the used cartridge and replace it with a new
one.
•
Close the lid.
•
Turn the handle clockwise until a piece of the film is
put out at the rear.
C. Replacing the cutter
•
Remove the screw in the cutter bar with a suitable tool
and take out the plastic insert.
•
Remove the used cutter and replace it with a new one
(blade showing inwards and downwards).
•
Replace the plastic insert and fix it with the screw.
훽
Lamination cartridge
훾
Tray
훿
Insert channel

Handle

Output channel

Cutter

Subject to technical changes without prior notice.
Technical data
Lamination system Cold lamination by
film rollers in cartridge
Working mode manual
Feed through speed variable
Maximum working width 215mm
Max. thickness of laminated item 1mm
Cutting system manual
Net weight 2kg
Dimensions (W x H x D) 380 x 205 x 170mm