13
• The device switches to cool down mode.
• The blower switches off automatically after approx. six minutes.
• Then disconnect the
power cord (1)
from the mains.
• Wait until the device has cooled down.
• Check the
power cord (1)
and plug for electrical and/or mechanical damage.
• Clean the
welding nozzle (8)
with a wire brush (available as an option).
1. Connect the mains voltage plug
2. Set the welding parameters
3. Switch on the heating with the
Heating On/Off key (16)
; wait three to
five minutes until the desired temperature is reached
4. If necessary,
adjust the direction of rotation of the drive (15 + 17)
5. Slide the
welding nozzle (8)
into the overlap
1. Remove the semi-automatic hot-air welder
2. Switch off the heating using the
Heating on/off key (16)
3. Wait for end of cool-down process (approx. six minutes)
4. Pull out mains voltage plug
The
operating unit (3)
consists of the
function keys
with which you can activate and/or deactivate the drive or
heating, the Confirm key for selecting the setpoints to be configured, as well as the
display
on which the current-
ly selected setting is displayed.
15 "Drive on/off" key
16 "Heating on/off" key
17 Minus/Plus keys
18 "Confirm" key
7. Quick Guide UNIDRIVE 500
17
18
17
16
15
7.1 Switching on/Starting
7.2 Switching off
8. Operating unit UNIDRIVE 500
8.1 Function keys
