26
Air
The air pump is
switched off
The air pump is switched on
Heating element
The heating element is
switched off
The heating element is
switched on
Cool down
When the air pump and heating element are switched on, the cool-down mode can be
activated by switching off the air pump. The heating element is switched off and the air
pump is run until the heating element has cooled down.
Caution–risk of burning:
The
air nozzle (12),
the
heating element for the protective
pipe (24)
, or other components may still be hot even after the cool-down process!
Changing
the drive
If you have mounted a “sidearm” or “quickarm” next to the standard welding arm “pedestal”, you can
make your selection on the right-hand side of the
touch panel (2)
. The choice of welding arm is repre-
sented as an icon on the Home screen. The icons mean the following:
Note:
To change between the three “pedestal”, “sidearm”, and “quickarm” drives, the motor must be
deactivated in advance in each case.
Pedestal
drive
By selecting this tab, the “pedestal” drive can be switched on or off.
The “pedestal” drive is switched off.
The “pedestal” drive is switched on.
Sidearm
drive
By selecting this tab, the “sidearm” drive can be switched on or off.
The “sidearm” drive is switched off.
The “sidearm” drive is switched on.
Quickarm
drive
By selecting this tab, the “quickarm” drive can be switched on or off.
The “quickarm” drive is
switched off.
The “quickarm” drive is switched on.
Welding
nozzle (12)
The
welding nozzle (12)
is in “Automatic” mode and is automatically swiveled in by
pressing the “Start/Stop Weld”
pedal unit (7)
.
The
welding nozzle (12)
is
in “Manual” mode and is
swiveled out.
The
welding nozzle (12)
is in
“Manual” mode and is swiveled in.
Clamping
rollers
The clamping rollers are closed in “Automatic” mode. The clamping pressure selected
is applied.
The clamping rollers are open in
“Manual” mode.
The clamping rollers are closed in
“Manual” mode.
8.5 Periphery
