112
Data Transfer
TPS400-5.0.1en
Data Transfer
With this special function measured data can be trans-
ferred via the serial interface to a receiver (e.g. a
Laptop). Using this type of transfer the success of the
transfer is
not
checked.
Job:
Selection of job from which data should
be transferred.
Data:
Select the data range to be transferred
(measurements, fixed points)
Format:
Select output format. Select Leica-GSI-
format, or your own format created in
the "Format Manager" and transfer to
the LGO/LGO-Tools.
[SEND] Starts
the
transmission.
Example:
Within the "data" setting "MEASUREMENTS" a data
set could be shown as follows:
11
....+00000D19
21
..022+16641826
22
..022+09635023
31
..00+00006649
58
..16+00000344
81
..00+00003342
82
..00-00005736
83
..00+00000091
87
..10+00001700
)
If the receiver is to slow in processing data
the data could be lost. With this type of data transfer
the instrument is not informed about the perfor-
mance of the receiver (no protocol).
GSI-ID’s
11
PtID
21
Horizontal direction
22
Vertical angle
25
Orientation
31
Slope distance
32
Horizontal distance
33
Height difference
41-49
Codes and attributes
51
ppm [mm]
58
Prism constants
81-83
(E, N, H) Target point
84-86
(E, N, H) Stand point
87
Reflector height
88
Instrument height
