2009-2013
FLH
RENEGADE
NOTE: See Fig. 1. Adapter plate (S001307)
angled ears determine rearward position and
straight and 90° edges determine forward
position.
1. Install tour pack adapter plate to base plate us-
ing button head bolts. Torque bolts to
8 ft.-lbs
.
•
(1) Adapter Plate- S001307
•
(1) Base Plate– S001090
•
(4) 1/4” x 5/8” Button Head Bolts– CS4089
2.
See Fig. 1
. Set base assembly on bench and
place tour pack on base assembly.
3.
See Fig. 2
. Open tour pack lid and temporarily
fasten tour pack to base assembly using (2) of
the (4) 1/4” x 7/8” button head bolts (CS4094).
4. Set tour pack and assembly on body.
5. Center tour pack to body, seat and grab handle.
6. Mark holes in body with scribe or equivalent.
7. Remove tour pack and assembly from body.
8. Drill holes in body with 5/16” drill bit and drill.
9. Remove tour pack from base assembly.
10.
See Fig. 3
. Place rubber gaskets on body and
install base assembly using the following hard-
ware.
•
(4) 5/16” x 1-1/4” Button Head Bolts– CB1163
•
(4) 5/16” Lock Washers– CW2046
•
(4) 5/16” Flat Washers– CW2009
11. Install tour pack support brackets inside trunk
body and fasten plates to assembly hardware.
Torque bolts to
17 ft.-lbs
.
•
(1) Tour Pack Support Brackets- S001091
12. Reinstall tour pack and fasten tour pack with all
hardware. Torque bolts to
8 ft.-lbs
.
13. Reinstall all tour pack wiring in proper locations.
14.NOTE: Tour pack ground strap will need
to be relocated to proper ground.
14. Reinstall tour pack liner.
Fig. 1
Rearward
Forward
Fig. 2
Temporarily fasten tour pack with hardware
Fig. 3
Base assembly on body
Adaptor plate-S001307
TOUR PACK
34
