1997-2001 FLH Renegade– Rev. 3
22
Installing Exhaust
1.
See Fig. 4.
Install mufflers to Lehman frame using original mounting hardware. Make sure mufflers
are level before making final cuts to exhaust pipes.
Note: Some adjustment may be required to get pipes even and level. DO NOT CUT TOO MUCH
MATERIAL FROM EXHAUST PIPES INITIALLY.
2.
See Fig. 3.
For RH exhaust, cut 2 1/2” from end of
head pipe.
3.
See Fig. 1.
For LH exhaust, cut 6 1/8” up on outside
radius of head pipe. This pipe may need to be tilted
downward to achieve proper angle with muffler.
4.
See Fig. 2.
Cut 1 3/4” off back of Lehman-supplied
LH drop pipe (LP1350).
5.
See Fig. 2.
Cut 5 1/2” off back of Lehman-supplied
RH drop pipe (LP1351).
6. Trim heat shields as needed for proper fitment.
7. Fasten exhaust clamps to joint using 5/16” X 1 1/4”
NF Gr. 8 bolt and 5/16” NF Gr. 8 nut. Position clamp
so they do not squeeze a slit open on sides and
clamp opening does not line up with slits in pipe.
Note: Pipe length may need to be adjusted accord-
ing to the following:
•
With or without light bar
•
Rare occurrences of body alignment
Fig. 1
LH Drop pipe
LP1350/1351
Fig. 2
Fig. 3
RH Drop pipe
