1997-2001 FLH Renegade– Rev. 3
2.
See Fig. 5.
Remove snap ring from one side of
large clevis pin on brake lever. Hold park brake
lever on its side and push release button at end
of park brake lever to allow clevis pin to slide out.
3.
See Fig. 5
.Place park brake lever within park
brake bracket, ensuring ratchet is secure on
cross brace. Attach with large clevis pin.
4.
See Fig. 5
. Attach park brake cable pulling
bracket to brake lever using small clevis pin and
cotter pin.
•
(1) Cable Pulling Bracket– LB1294
•
(1) Clevis Pin– CC3106
•
(1) Cotter Pin- CC4017
5.
See Fig. 6.
Route left park brake cable above
differential and under motorcycle frame, attach-
ing cable ties to cable and frame, and install in
left hole in handle mount.
6.
See Fig. 7.
Route right park brake cable up
around axle and forward to right hole in handle
mount.
7.
See Fig. 7
. Secure both cables to upper rear
pinch block with clamp (GC0108).
8.
See Fig. 8
. Secure cable retaining nuts to handle
mount with 7/8” wrench.
9. Check for tire clearance.
10.
See Fig. 8.
Thread one 5/16” NF nut onto each
brake cable. Place threaded end of brake cables
through holes in cable bracket. Thread second
nut onto each brake cable.
11. Adjust park brake cables at handle to engage at
3–4 clicks.
Note: Take up slack in cables before tightening
ends to ensure good adjustment range with
threaded end of brake cables.
19
Fig. 6
Left park brake cable
Fig. 7
Fig. 8
Cable routing
Cable retaining nuts
Adjuster nuts
Attach clamp
Fig. 5
