1997-2001 FLH Renegade– Rev. 3
15
5. Support swingarm with jack stands.
6.
See Fig. 5.
With differential assembly on lift,
slide belt over LH axle tube and against center
housing.
7.
See Fig. 5
. Set differential assembly on swin-
garm adapter plates. Slide differential as far
forward as possible. Set jack stands under
axle tubes.
8. Tighten pinch block hardware just enough to
allow differential to slide on swingarm adapter
plates.
9.
See Fig. 5
. Remove upper, lower and rear
housing plates.
10.
See Fig. 6
. Carefully slide belt over pulley.
Reinstall housing plates with original hardware us-
ing Loctite 242. Install all hardware before tighten-
ing. Torque hardware to
17 ft. lbs
Fig. 5
Install belt
Fig. 6
Remove plates
