2006-2013 FXD Renegade Rev. 6
1.
See Fig. 2.
Remove snap ring from one side of large clevis pin
on brake lever. Hold park brake lever on its side and push
release button at end of park brake lever to allow clevis pin to
slide out.
2.
See Fig. 2
.Place park brake lever within park brake bracket,
ensuring ratchet is secure on cross brace. Attach with large
clevis pin.
3.
See Fig. 2
. Attach park brake cable pulling bracket to brake
lever using small clevis pin and cotter pin.
(1) Cable Pulling Bracket– LB1294
(1) Clevis Pin– CC3106
(1) Cotter Pin- CC4017
4.
See Fig. 3.
Route left park brake cable above differential
and under motorcycle frame, attaching cable ties to cable
and frame, and install in left hole in handle mount.
5.
See Fig. 4.
Route right park brake cable up around axle
and forward to right hole in handle mount.
6.
See Fig. 4
. Secure both cables to upper rear pinch block
with clamp (GC0108).
7.
See Fig. 5
. Secure cable retaining nuts to handle mount
with 7/8” wrench.
8. Check for tire clearance.
9.
See Fig. 5.
Thread one 5/16” NF nut onto each brake
cable. Place threaded end of brake cables through holes in
cable bracket. Thread second nut onto each brake cable.
10. Adjust park brake cables at handle to engage at 3–4 clicks.
Note: Take up slack in cables before tightening ends to
ensure good adjustment range with threaded end of brake
cables.
Fig. 6
Cable retaining nuts
Adjuster nuts
Left park brake
cable
Fig. 4
Cable routing
Attach clamp
14
Fig. 3
Fig. 2
Fig. 5
