18
3.
See Fig. 4
. Place mufflers over exhaust extensions with clamps in place. Attach mufflers to brack-
ets using the original flange head bolts. Torque hardware to
20 ft-lbs
.
4. Adjust the extensions and mufflers until the best fit is achieved. Make sure the mufflers are at the
same angle relative to the body frame otherwise the gap around the muffler to the body may differ.
Torque the OEM exhaust clamps to
35 ft-lbs
.
5.
See Fig. 5
. Trim both heat shields. Cut
shields behind rear clamp as shown.
6.
See Fig. 6.
Bend front tab on LH heat shield
as shown.
7. Reinstall heat shields in original locations.
Fig. 4
Remove rear
section from shield
RH heat shield shown
Before
After
Fig. 5
Fig. 6
