LEGRAND Trimod MCS 10, User Manual, Page: 39 / 60

Trimod MCS
U
ser manual
39
6.4.4 Events
Events
Log View
All This displays all the events
Critical
This displays the events that have generated
critical alarms
Warning
This displays the events that have generated
non-critical alarms
Info
This displays the events that have generated
simple warnings
6.4.5 Tools
Battery
Battery Test Automatic
This performs a test on the batteries to check their
status and performance
Batt. Calibration
This calibrates the batteries, finding the discharge curve.
For precise information about the battery charge status, it is necessary to
perform the calibration in the following cases:
- after installation and first start-up;
- in case the batteries are replaced;
- every six months after the first year of the EPS life.
Battery cycle
This carries out a battery test and their equalization to check the status,
the performance and to maximise the battery life.
Signalling Test (*)
This carries out the test of the status indicator signalling (green, orange and red) and of the
acoustic notfication.
LCD Display Test
(*)
This performs the test of the alphanumeric display. Press the ENTER key to display all the availa-
ble characters.
(*) Available in the “Service Mode” only
Assistance
Display
Identifier
This displays the code to communicate to the Technical Support Service.
Use code Enter the code provided by the Technical Support Service.
CM errors recovery
This deletes the error memory detected by the command board.
It restores only the resettable errors.
6.4.6 Log Out
It is possible to set a password to prevent non-authorised personnel to modify the configuration.
By choosing a password, it is necessary to enter a private session to modify the settings. At the end of the operations use
the "Log Out" menu to leave the private session.
If the password has been forgotten, it is necessary to contact the LEGRAND Technical Support Service.