33
NOVO Technical Handbook - NE41 15013-02 v2.0
6
Programming/configuration modes
6.1
General
NOVO can be configured in a number of ways depending on model and market.
It can be done with the buttons on the unit, via the Management Portal (CMP), with a
software programmer, with a
HAND
terminal or with the
LPP
protocol.
Software programmer is available in certain markets. Contact your distributor for
information.
For information about CMP see CMP – User manual, NE41 15011-02.
Model
Buttons
Programmer
CMP
HAND
LPP
NOVO IP/MOBILE
x
x
x
NOVO PSTN/GSM
x
x
x
x
x
NOVO PSTN+
x
x
x
x
NOVO PSTN
x
x
x
x
Table 20.
Programming options for NOVO models.
This document will offer a description of how NOVO can be configured with the unit’s
buttons as well as a short summary on how to configure with HAND and LPP. For
information about CMP or Programmer please contact NEAT or your distributor.
Another way to configure all models of NOVO is to connect the unit to a computer
with
USB
and in the file explorer copy the configuration to NOVO This is also how
audio files are copied to NOVO.
Only audio files validated by NEAT and configurations created by NEAT or in a
designated NEAT programmer should be used.
6.2 Programming via buttons
Programming using the buttons can be initiated while the unit is in
Idle
mode.
The unit is in Idle mode when it is not processing an alarm event.
When programming with the buttons is initiated the unit enters
programming mode
.
While in programming mode NOVO does not handle incoming alarm events.
Via the buttons the unit can enter Control Mode and from that mode it can enter
Service mode.
