Owner’s Manual of DA2131-V1
A
- 9 -
2.2.2 Pole Mounting
Step 1.
Turn the DA2131-V1
A
over. Feed a pole mounting tie through the middle hole of the rear
structure.
Step 2.
Mount DA2131-V1
A
securely to the pole by fastening both mounting ties tightly.
Step 3.
Now you have completed the hardware installation of DA2131-V1
A
as shown in the figure below.
Figure 2-6
Pole Mounting
2.2.3 Surface Mounting
Notice the rear bracket flange of the DA2131-V1
A
contains a screw hole in each corner for mounting to a flat
surface with appropriate screws (provided).
2.2.4 Using an External Antenna
If you prefer to use the external antenna with SMA-type connector for your application instead of the built-in
directional antenna, please follow the steps below.
Step 1.
Connect your antenna with the SMA-type connector on the bottom of DA2132-V1
A
.
Step 2.
Power on the DA2131-V1
A
, and then go to
Wireless Settings-> Basic
to configure the
Antenna Switch
from “
Internal
” to “
External
”.
1.
If you are going to use an external antenna on DA2131-V1
A
, get some cable in advance.
2.
Users MUST power off the DA2131-V1
A
first before connecting the external antenna to it.
Do not switch from built-in antenna to the external antenna from WEB management
without physically attaching the external antenna onto the DA2131-V1
A
; otherwise,
damage might be caused to the Outdoor NWAP itself.
Mounting Tie
