Installation Instructions
LPE1U
15
Cart Use and Maintenance
WARNING:
Exceeding the weight capacity can result in
serious personal injury or damage to equipment! It is the
installer’s responsibility to make sure the weight of all
components attached to the LPE1U does not exceed 200 lbs
(90.7 kg). Use with heavier televisions may result in instability
causing tip over resulting in death or serious injury. See
Figure below for reference.
WARNING:
RISK OF SERIOUS INJURY OR DEATH!
Placing a remote control or toy on the cart may encourage a
child to climb onto the cart causing the cart to tip over onto
the child. DO NOT place remote controls or toys on the cart!
WARNING:
RISK OF SERIOUS INJURY OR DEATH!
Relocating audio and/or video equipment to the cart may
result in the cart collapsing or overturning onto a child. DO
NOT relocate audio and/or video equipment to the cart!
WARNING:
CART CAN TIP OVER RESULTING IN
INJURY! Do not allow children under 16 to move cart. Only
adults should move this cart.
WARNING:
CART CAN TIP OVER RESULTING IN
INJURY! Move cart slowly and with the cart set at its lowest
position. Use handles for additional stability. Push, don’t pull
cart. (See Figure 24)
NOTE:
The LPE1U cart has no user serviceable parts.
NOTE:
The LPE1U cart can support screen sizes up to a
maximum of 86" wide.
NOTE:
The LPE1U cart is intended for institutional use.
1.
Always place cart on a level surface.
Figure 24
2.
Always lock the wheels when the cart is not moving by
pressing down the locks on wheels. (See Figure 25)
Figure 25
3.
Check and tighten the hex nuts on the casters occasionally.
(See Figure 26) These should be checked especially after
use on uneven ground.
Figure 26
Troubleshooting
If lifting function does not work properly, try to following
troubleshooting steps. If none of these work, contact customer
service.
1.
If there is uneven movement, initialize the control box
(reset)
•
Hold "Down" button until lift has reached it’s lower
limit.
•
Briefly release "Down" button
•
Press and hold "Down" for five seconds, wait until
all movement has stopped, then release
2.
If there is no movement, check the following
•
Check all cable connectors between controllers
and actuators.
•
Check power cable connection to control box.
3.
If there is slight movement and then reverse travel, check
for any obstructions that may be interfering such as cables
or peripheral devices.
4.
Contact customer service if none of the above steps fix the
problem.
Only move cart
at its lowest
height position!
2
x 4
3
