4
Installation Instructions
PTS
25-PTS-2000 ASSEMBLY
CAUTION:
DO NOT attempt to mount the Flat Panel Display in
an inverted position. Mounting the Flat Panel Display
in an inverted position may cause overheating and
extensive damage to the Flat Panel Display.
Assemble the 25-PTS as follows:
1.
Using four 5/16-18 X 5/8” button head cap screws and 5/16-18
Nylock nuts, secure the post assembly to the base assembly
(see Figure 3).
2.
Attach latching flag to faceplate using 10-24 Phillips head
screw, Nylon washer, and Nylock nut (see Figure 4).
3.
Using two washers (one Nylon .38 ID and one SAE 3/8”) and
Nylock nut, secure the top of the single upright spacer to the
top stud of the upright post (see Figure 3 and Figure 4).
4.
Using two 3/8 ID Nylon spacers, two SAE 3/8” washers, and
Nylock nut, secure the bottom of the single upright spacer to
the bottom stud of the upright post (see Figure 3 and Figure 4).
FIGURE 2. POST TO BASE PLATE
Top
Bottom
FIGURE 3. SINGLE UPRIGHT SPACER
Nylock Nut
3/8” Washer
3/8” Washer
Nylock Nut
Nylon Spacer
Nylon Spacer
Nylon Spacer
FIGURE 4. ASSEMBLY
SWIVEL ADJUSTMENT
