Video
Use BNC coaxial cable only.
Alarm Input
Before connecting sensors, check driving voltages and output signal types of the sensors. Since output signal
are divided into Open Collector type and Voltage Output type in general, the wiring must be done properly after considering
those types.
Signal
Description
IN COM+
The electric power source to drive input circuit. Connect the (+) wire
electric power source to drive the Sensors to this port as shown in the above
circuit.
IN1 -, IN2 -, IN3 -
Connect the outputs of sensors to each port as shown in the above circuit.
If you want to use Alarm Input, the types of sensors must be selected in OSD menu.
Open and Normal Close. If wrong sensor types are selected, alarms should be activated reversely to sensor inputs.
Normal Open
Output Voltage is high state when sensor is activated
Normal Close
Output Voltage is high state when sensor is not activated
Relay Output
The maximum loads are as follows: 24 VDC ; 1A.
29
Before connecting sensors, check driving voltages and output signal types of the sensors. Since output signal
are divided into Open Collector type and Voltage Output type in general, the wiring must be done properly after considering
Description
The electric power source to drive input circuit. Connect the (+) wire
electric power source to drive the Sensors to this port as shown in the above
circuit.
Connect the outputs of sensors to each port as shown in the above circuit.
If you want to use Alarm Input, the types of sensors must be selected in OSD menu. The sensor types are divided into Normal
Open and Normal Close. If wrong sensor types are selected, alarms should be activated reversely to sensor inputs.
ut Voltage is high state when sensor is activated
Output Voltage is high state when sensor is not activated
s: 24 VDC ; 1A.
Before connecting sensors, check driving voltages and output signal types of the sensors. Since output signal types of the sensors
are divided into Open Collector type and Voltage Output type in general, the wiring must be done properly after considering
The electric power source to drive input circuit. Connect the (+) wire of
electric power source to drive the Sensors to this port as shown in the above
Connect the outputs of sensors to each port as shown in the above circuit.
he sensor types are divided into Normal
Open and Normal Close. If wrong sensor types are selected, alarms should be activated reversely to sensor inputs.