1. Carefully lift the appliance out of the packaging taking care not to damage the ceramic components in the
separate carton.
2. Remove the magnetic trim and store to one side to prevent any damage.
3. Remove the louvred panel by lifting
up and pulling forwards.
4. Slacken the five machine screws on
the top retaining strip (Fig. 2a).
5. Unscrew the two securing screws
from the lower infill panel and remove the panel.
Tilt the glass forwards and slide out (Fig. 2b).
6. Cut the foam sealing strip (in plastic bag supplied) to length and stick a continuous strip down the two sides
and across the top of the radiant box. When the box is placed against a flat surface the foam strip will form a
seal around the boxes flange.
7. Carefully lift the appliance into position in the fireplace opening and check that the flange of the radiant box
fits flush against the sealing face with no gaps present.
8. Remove the five screws that secure the burner tray to the box, two on the front leg, two at the rear of the tray
and one holding the cam bracket to the front of the fire box. Undo the nut that holds the cam assembly to the
connecting rod. Remove the burner tray and place to one side (Fig. 3).
INSTALLATION PROCEDURE
5
Fig. 3
Burner tray
Blanking plate
Foam Sealing Strip
Magnetic Trim
2 x Securing Screws
Fig. 2a
Fig. 2b
5 x Machine Screws
Louvred Panel
x 2
Securing Nut
Connecting Rod
Cam Bracket
Cam
Assembly
