13
preset speed intended for film laminating. When the function switch is in
pouch position the rubber rolls will move at a preset speed designed for
pouch laminating.
11. The SIGNMASTER 44 is designed with a heated rubber roll. To operate the
heat controller, depress the on/off heat button and observe that the
temperature display lights indicate present temperature of heat roll. To set
the temperature, briefly depress red button under the temperature display and
temperature set point will appear. To increase temperature setting while set
point is displayed, depress and hold red button until desired point is reached.
To decrease temperature setting while temperature set point is displayed,
depress and hold blue button under temperature display until desired set
point is reached. In each case, approximately five seconds after release of
red or blue button, temperature display will revert to actual temperature of
rubber roll. Display will increase or decrease until new setting is reached. To
change the temperature reading from Fahrenheit to Centigrade depress and
hold blue button approximately five seconds until display reads degrees F or
C. The reading will change back and forth by gently tapping blue button.
RED BUTTON
TEMPERATURE
DISPLAY
MOTOR SPEED
CONTROL
FORWARD/REVERSE
SWITCH
FUNCTION SELECTOR
SWITCH
MAIN DRIVE
SWITCH
HEAT CONTROL
SWITCH
BLUE BUTTON
