LED World HUEDA, Installation Sheet

Page: 4 / 7

4/7
Pinout Connection Guide
RJ45 568B Connection Pinout
1
RJ45 568B Pinout Table
Pin No. Wire Color Function
1 White/Orange Data +
2 Orange Data -
3 White/Green None
4 Blue None
5 White/Blue None
6 Green None
7 White/Brown May be used as 2nd ground
8 Brown Ground
Pin No. Function
1 Ground
2 Data -
3 Data +
XLR-3 Connection Pinout
2 3 4 5 6 7 8
XLR-3 Pinout Table
1 2
3
1 2
3
Female Male
The following diagrams/tables indicate the appropriate connections for patching your own CAT5/RJ45, and
XLR-3 splice cables. These diagrams are for general reference and may slightly differ between different cable
manufacturers.
Mode Description
1 Full Color Fade #1
2 Reverse Rainbow Fade
3 Random Full Color Fade
4 7 Color Jump
5 RGB Fade In / Fade Out
6 RGB Fade In to Off
7 RGB On to Fade Out
8 RGB Jump
9 Full Color Fade #2
10 Pastel Color Fade In / Fade Out
Dynamic Mode Chart
T h e D y n a m i c M o d e t o o l p l a y s f a c t o r y -
programmed scenes. Choose up to 10 different
scenes. Short press switches/pauses the mode.
Long press adjusts speed of the dynamic mode
Troubleshooting
For thorough troubleshooting of LED strip light and xtures, see LED xture installation guides.
LED xtures not responding to touch
LED xture responding incorrectly
Ÿ
Ensure the blue indicator light is on by pressing ‘Power Button’.
Ÿ
Ensure the appropriate zone number was pressed prior to controlling the DMX decoder/xture. For example, if you
know the xture is addressed to zone 1, press 1 prior to controlling.
Ÿ
Ensure the individual zone has not been turned off. Pressing zones 1-3 will turn the specic zone ON/OFF. Additionally,
long pressing R, G, B, W will increase/decrease individual brightness and tapping will turn R, G, B, W ON/OFF.
Ÿ
Ensure the DMX decoder/xture is addressed properly. For example, address ‘001’ will respond to zone 1 of the
controller.
See ‘Setting the DMX Address’ on page-2 for additional addressing information.
Ensure all wiring connections are correct. Reversing the Data + and Data - will cause lights to icker and not respond to
controller.
Ÿ
Power connections of all components (drivers, DMX decoders/xtures, DMX controller).
Ÿ
DMX Data connections -see ‘Pinout Connection Guide’ and ‘System Diagram’ for Rj45 hard-wiring connections.
Ÿ
DMX decoder PWM output connections -see ‘System Wiring Diagram for CH 1-4 connections
INSTALLATION SHEET HUEDA ™ -Multi Zone LED Controller
INSTALLATION SHEET
HUEDA ™ -Multi Zone LED Color Controller
Copyright © 2015 LED WORLD INC™. All Rights Reserved. We are not responsible for errors or omissions. Product and specications subject to change without notice. Registered trademarks are owned by their respective registers, or licensee(s).
LED World Inc. | #130 10615 48 ST SE | CALGARY, AB T2C 2B7 | CANADA | Version 1.4 10/19/15