Digital Transmitter
Rio Rancho, NM
19
For body worn operation, this transmitter model has
been tested and meets the FCC RF exposure guidelines
when used with the Lectrosonics accessories supplied or
designated for this product. Use of other accessories may
not ensure compliance with FCC RF exposure guidelines.
Contact Lectrosonics if you have any questions or need more
information about RF exposure using this product..
This device complies with FCC radiation exposure limits as
set forth for an uncontrolled environment. This device should
be installed and operated so that its antenna(s) are not co-
located or operating in conjunction with any other antenna or
transmitter.
This device complies with ISED Canada radiation exposure
limits as set forth for an uncontrolled environment.
Cet appareil est conforme avec les normes d’Industrie
Canada concernant les limites d’exposition aux radiations
pour un environnement incontrôlé.
This radio transmitter [IC: 8024A-DCHT, DCHT/E01] has been
approved by Innovation, Science and Economic Development
Canada to operate with the antenna types listed below,
with the maximum permissible gain indicated. Antenna
types not included in this list that have a gain greater than
the maximum gain indicated for any type listed are strictly
prohibited for use with this device.
Lectrosonics provides dipole “whip” antennas for use
with the DCHT, DCHT/E01 transmitter. The antennas are
cut to the frequency range shown below and include a 50
Ohm SMA connector.
Antenna Model
Freq Range (MHz) Gain (dBi)
AMM19
470.100 - 537.500
2.15
AMM22
537.500 - 607.950
2.15
Supplied Accessories
AMJ19
Swiveling Whip Antenna with Standard SMA Connector,
Block 19.
AMJ22
Antenna with swiveling SMA connector, Block 22.
40073 Lithium Batteries
DCHR is shipped with two (2) batteries. Brand may vary.
Optional Accessories
26895:
Wire belt clip
BCSLEBN:
Spring-loaded belt clip
