LECTRICEBIKES.COM | 602.715.0907
35
The Pedal Assist may be activated as soon as you step onto the
pedals and the bicycle is in motion. ALWAYS be seated on the bicycle
and engage at least one brake before starting to pedal. DO NOT place
one foot on a pedal then throw your other leg over the bicycle or your
eBike could accelerate unexpectedly.
To prevent serious injury or death:
• Exercise extreme caution when using the twist throttle. When at a
complete stop with the bicycle turned ON, be careful not to twist
the throttle or the bicycle could accelerate and cause you to crash.
• Do not engage Walk Mode when riding or sitting on your Lectric
eBike. Holding the minus (-) button will engage the motor up to a
walking speed.
• Refer to the tightening torque section (p.19) of this manual in
order to properly torque the chain tensioner and make sure it
is in the correct position for proper function. If the chain is too
tight and you are walking the bike in PAS 1-5, the front chainring
and pedals will move which will cause PAS to activate. The
acceleration from this activation could cause a crash. To avoid
this, walk the bike in PAS 0.
To start:
1. Insert key and turn counterclockwise to the ON position. The key
will be parallel with the frame and you will not be able to remove
the key from the battery pack.
2. Hold down the button located on the left handlebar until the
display comes on.
3. Select a Pedal Assist (PAS) level using the plus (+) and minus
(-) buttons. PAS 0 provides no motor assist. PAS 1 is the lowest
level of assist and PAS 5 is the highest level of assist.
To end your ride:
When the bicycle is at a complete stop, press and hold the button
to turn the display OFF. This ensures the motor will not activate until
the display is turned ON again and you are ready to ride.
WARNING!
