Leaf LT88 / LT88E manual
Page 8
Of 22
3.1 RJ12 control port
The 6 wire RJ12 port enables the LT88/E to be controlled by a proprietary LEAF
controller such as the TC3.
3.2 4 way DIP switch module
The rear panel accessible 4 position DIP switch controls functionality of the LT88/E.
The table below summarizes the settings:
NOTE: The interface will only read the DIP switch settings on power-up. The unit must
be powered off and then back on again for it to respond to any change of the DIP
switch settings.
DIP SWITCH
OFF (down)
ON (up)
1
Global IR direction IN
IR RX detectors at LTB1/E
breakouts
IR TX blasters at LT88/E
Global IR direction OUT
IR RX detectors or devices at
LT88/E
IR TX blasters at LTB1/E breakouts
2
IR Input device type
(Applies when DIP 1 =ON)
IR RX detectors (e.g. Leaf
Hammerhead) at
LT88/E
IR Input device type
(Applies when DIP 1 =ON)
IR direct drive from control system*
(5 volt only) at LT88/E
*Must connect IR IN with a stereo
(tip,ring,sleeve) plug at the Leaf end
with the ring floating / not connected
or with the ring connected to tip.
3
Normal Mode
Compatibility Mode
4
Future Function
Future Function
Table 1: Dip Switch Settings
3.3 Digital Coax (S/PDIF) audio inputs:
The upper row of RCA sockets 1 to 8 are configured as digital coax (S/PDIF) stereo
audio input ports. They can be used as either alternative audio inputs (selectable with
discrete Audio Only commands) or the input points for audio only sources.
3.4 Stereo RCA analog outputs
The lower 2 rows of RCA sockets 1-8 are configured as stereo analog audio outputs
for connection to local devices such as centralised external amplifiers.
The source audio for these outputs can be either an HDMI input source, digital coax
(S/PDIF) stereo connector input or audio return from a zone breakout input.
The RCA outputs maybe routed manually or automatically (the default).
With automatic routing active, the RCA audio outputs will follow the zone audio output
of the same number. (example: If zone 4 is selected to source 2, then in automatic
mode the RCA audio will also come from source 2).
