Hardware
installation manual of the multi-axis drive MX4660
Leadshine Technology Co., Ltd
Leadshine America, Inc.
Page 24/28
3/F, Block 2, Nanyou Tianan Industrial Park, Shenzhen, China
25 Mauchly, Suite 318, Irvine, CA 92618, USA
Tel: 86-755-26409254
Fax: 86-755-26402718
Tel: 1-949-608-7270
Fax: 1-949-608-7298
Web:
www.leadshine.com
Email:
Web:
www.leadshine.com
Email:
controller connected through the DB25 connector.
GND
Common ground.
OPTO2
Power Input for opto-couplers for Input1 and Input2. Defaut is +12VDC and a +12Vdc Out is
available on board. A resistor is required for current limit when input voltage is higher than +12
VDC. See figure 15 for more information.
This design makes digital inputs can work with external
devices NOT only rated at 12 VDC with higher reliability and more flexiblity, such as working
with proximity sensors rated at different voltages.
Input 3
General Purpose Input. This pin is connected to pin 12 - “Output 3” - of the DB25 connector. Used
to forward the digital output signal, sent from the connected external device here, to the motion
controller connected through the DB25 connector.
Input 4
General purpose Input. This pin is connected to pin 13 - “Output 4” - of the DB25 connector. Used
to forward the digital output signal, sent from the connected external device here, to the motion
controller connected through the DB25 connector.
GND
Common ground
+12Vdc Out
Auxiliary power output (+12V @ 100mA). This auxiliary power outputs can be used as an input
for OPTO1 or OPTO2.
Input 5
General purpose Input (12V sourcing). This pin is connected to pin 10 - “Output 5” - of the 26-pin
low-profile header. Used to forward the digital output signal, sent from the connected external
device here, to the motion controller connected through the 26-pin low-profile header. A 2
nd
parallel port or an external device like SmoothStepper is required for this function.
Input 6
General purpose Input (12V sourcing). This pin is connected to pin 11 - “Output 6” - of the 26-pin
low-profile header. Used to forward the digital output signal, sent from the connected external
device here, to the motion controller connected through the 26-pin low-profile header. A 2
nd
parallel port or an external device like SmoothStepper is required for this function.
GND
Common ground
+12Vdc Out
Auxiliary power output (+12V @ 100mA). This auxiliary power outputs can be used as an input
for OPTO1 or OPTO2.
Input 7
General purpose Input (12V sourcing). This pin is connected to pin 12 - “Output 7” - of the 26-pin
low-profile header. Used to forward the digital output signal, sent from the connected external
device here, to the motion controller connected through the 26-pin low-profile header. A 2
nd
parallel port or an external device like SmoothStepper is required for this function.
Input 8
General purpose Input (12V sourcing). This pin is connected to pin 13 - “Output 8” - of the 26-pin
low-profile header. Used to forward the digital output signal, sent from the connected external
device here, to the motion controller connected through the 26-pin low-profile header. A 2
nd
parallel port or an external device like SmoothStepper is required for this function.
GND
Common ground
