12. ETHERNET CONTROL (LV 5838 ONLY)
90
F•1
12.3
Time Server Function
You can configure the LV 5838 so that it periodically connects to a time server on the network
and queries the time.
12.3.1
Procedure
1.
Configure the Ethernet settings on the ETHER&REMOTE tab.
Set Time Server to ON. Set the ETHERNET SETTING IP Address, TIME SERVER
SETTING IP Address, and Time Zone. For details on Time Zone, see the next section.
[Reference] See section 5.
2, “Configuring the Ethernet and Remote Settings (LV 5838 only).”
→
SYSTEM SETUP
→
NEXT TAB
→
Figure 12-5 ETHER&REMOTE tab
2.
Press
COMPLETE.
3.
Restart the LV 5838.
If you didn't make any changes, you do not have to restart.
4.
Connect the Ethernet port on the rear panel to the network.
Use a UTP cable (category 5).
The LV 5838 connects to the NTP server at the following times.
• When you press F•1 COMPLETE in SYSTEM SETUP
• Once every approximately 10 minutes
When the LV 5838 connects normally to a time server, the date and time are displayed
at the upper left of the screen.
Otherwise, “SNTP:ERR” appears in the top row, and the time that was set up to that
point appears in the bottom row.
Normal connection
Connection error
F
•3
SYSTEM
F•1
USO
RESTRITO
