Leader Like Me, Instruction Manual

Page: 12 / 61

Preparing To Sew
10
Threading the bobbin case
Shuttle cover
Bobbin case
Latch
Tension spring
Ensure the Power Switch is
turned off when removing or
inserting the bobbin case.
a: Remove the sewing table from
the machine by pulling it to the left.
Open the Shuttle Cove by
pulling down the tab on the left of
the cover.
Raise the needle to its highest
position by rotating the hand wheel
towards you.
b: To remove the Bobbin Case
from the shuttle pull back the Latch
on the bobbin case and pull
straight out of the shuttle.
c: Place a Bobbin in the Bobbin
Case ,making sure the thread
feeds clockwise from the bobbin.
d: Draw the thread through the slot
in the case.
Continue to draw the thread under
the Tension Spring and
through the opening.
Pull out about 4" (10cm) of thread.
e: Raise the needle by turning the
hand wheel towards you.
Open the Shuttle Cover .
Hold the Bobbin Case by the
hinged Latch .
Insert the bobbin case fully into the
shuttle race and release the latch.
f
: Make sure that the latch located
into the notch at top of the shuttle,
closed the Shuttle Cover .
Note
:
When you insert the bobbin case.
You must push the bobbin case as
far as it goes, and you can hear the
“Click”.