lbx WB-S, User Manual

Page: 4 / 30

4
·
Ensure that the main cable does not touch the surface.
·
Do not damage the power cord and always use the specified one. In case of damage, the
power cord must be replaced.
·
Do not unplug the power cord during operation.
·
Unplug the cord before maintenance, after use, and if the instrument is running abnormally.
·
Do not touch the power plug with wet hands.
·
Wear gloves when repairing and maintaining the instrument.
Other necessary considerations:
·
When touching the inner wall of the door, do it carefully, as it may be hot.
·
The internal parameters must be set by the specific management person to prevent the function
of the controller program from being disturbed by an unknown setting.
·
The equipment must be placed at least 20cm away from the wall and from any objects.
·
Open and close the door gently to prevent damage to the equipment.
·
Do not expose the equipment surface to volatile chemicals.
· Keep the equipment clean, both the inside and the outside.
Safety alarms:
·
In case of a controller block, Holzer error, busbar under voltage, busbar over voltage or
communication failure, the speed bar will show the fault code and the controller will
automatically stop.
·
In case of a temperature or speed alarm, the identifier ALM1 will light up and the buzzer
sound will go off. Stop it by pressing any key.
·
When turning off the equipment, always press to stop any ongoing functions before
turning off the device.
·
In case of a fault of the temperature sensor or the controller itself, the indicator – will display.
Carefully check the temperature sensor and its wiring.