LAZBOY Premier Series, Owner'S Manual

Page: 49 / 60

49
For HELP, call La-Z-Boy
®
Hot Tubs at 1.800.465.2933.
TROUBLESHOOTING
If a problem arises, you can check this list for a quick solution. If this does not resolve
your problem, please call your local dealer for servicing information.
Important: Most problems can be quickly resolved by resetting the GFCI break-
er. Try this first before proceeding.
Problem Cause Solution
Breaker trips Wiring error Spa Neutral wire not connected to GFCI (connected
to Neutral bus)
Wrong GFCI GFCI breaker is wrong size or type
Chlorine level
changed
suddenly Ultraviolet
radiation
(sunlight) Spa is located in direct sun and ultraviolet radiation
destroys free chlorine.
Circulation
pump not
running in
constant
filtration mode
Temperature
limit reached This is normal. When the water temperature is 2ºF
over the set point and warmer than 95ºF, the pump
automatically turns OFF in constant filtration mode
to prevent overheating the water.
Dirty filters Thoroughly clean filters. If problem persists, oils
may have accumulated in the spa. Flush and rinse
plumbing. Drain tub and thoroughly clean shell.
Foamy
water Soaps, skin
oils, or
undissolved
sanitizer
particles Close the air control valves and allow filtration cycle
to run
Add defoamer
Drain and clean spa
Clean or change filters
Light doesn’t
work LED burnt
out Change LED
Loose wire Reconnect wire
Loose plug Reconnect plug
Leak Loose
connection Check and hand-tighten unions at heater & pumps,
or clamps on jets
Drain open Close drain valve or replace cap