A__madi4 User Guide
Version: 10.0.0/4
50/68
12. The RAVENNA Web UI
RX Stream Properties: Pre-configured
Now open a RAVENNA Web UI connection to the receiving device and, if possible, select the TX stream from the
Connect
menu - the 'RX Stream Properties' window opens.
The
Stream Source
will be completed automatically from the stream's SDP information, and the
Receiver
Settings
will be pre-configured according to the default settings.
If you need to define two separate paths for the SDP information, then you can enter the redundant stream's SDP
path into the lower Stream Source field.
'RX Stream Properties' (single SDP)
'RX Stream Properties' (main & redundant SDP)
The only other difference from a non-redundant stream is that the
Streams
entry, under 'Receiver Settings', shows
two lines - one for the main and one for the redundant source. By default, these are assigned to the media's two
RAVENNA interfaces (ra0 and ra1), and so there is nothing further to do. If you wish to receive the stream without
redundancy, then switch one of the interfaces to
not subscribed
.
All other properties should be configured as for a non-redundant stream, see
When a RX stream is configured for redundancy, you will see the following message in the information area: "This
session contains a duplication group".
Once you click
Apply
, the RX stream becomes active and appears at the bottom of the
RX stream
list on the
The receiver will now combine the data arriving at both of the interfaces to reconstruct the original stream.
