7
A STEELFORT PRODUCT
OPERATION
Please wear suitable clothing and work gloves when
using this hand saw. Before each use, make sure the
hand saw is running normally. The on /off switch
should be operating normally at all times , if the
on/ off switch is damaged or not working correctly
please do not use the hand saw. To reduce the risk of
injury make sure all protective clothing is being used
and keep all body parts and clothing away from the
Bar and chain area of the hand saw while being used.
When loosening the start switch, the power must be
turned off. If the switch is damaged, stop using the
device. Make sure the voltage of the power supply
is consistent with the voltage on the nameplate.
The risk of injury can be reduced by wearing
protective devices and ensuring that the devices are
functioning properly.
INSTALLING THE CHAIN GUIDE BAR
Please make sure at all times when working on the
battery powered Hand chainsaw that the battery has
been removed from the hand saw
Place the drive link of the saw chain into the guide
bar.
NOTE: When the saw chain has been placed into the
guide bar the chain cutting tooth should be facing
forward, as per the image below. The hand saw
has a device to adjust the saw chain tension, when
installing the guide bar make sure that the adjusting
block is positioned correctly into the adjusting slot at
the rear of the guide bar”.
Put the chain into the guide bar.
NOTE: The direction of the cutting teeth.
Align the pin hole and instale the reverse hole and
chain.
ADJUSTING THE TIGHTNESS OF CHAIN
The adjustment standard is to lift the chain in the
middle of the guide bar by hand and expose 1-3 drive
links.
Twist the adjusting screw clockwise to tension the
chain, counterclockwise is for loosening
Drop-down chain
Pull down the chain to expose the three drive links.
CONDITIONS OF WORK
The hand saw has been designed to cut branches
up to 60mm in diameter, to perform tasks that are
outside of this requirement will reduce the battery
run time. Please make sure the saw chain is in good
condition at all times, to use the hand saw with a dull
saw chain will reduce the battery run time.
BATTERY
Battery Packing: Pay attention to aligning slots,
inserts.
Button press and pull out the battery pack
Extension rod control joint
Open the package, check whether the components
are all there:
•
Electric Coarse Branch
•
Battery
•
Charger
•
Instruction Manual & Warranty Cord
Supply Voltage V
21/24
The Most Powerful mm
100mm
Battery
Li-ion
Rated Voltage
100-240V AC, 50-60Hz
Force Voltage
DC 21/24
Charging Current
0.8
1.
The new chain will be stretched in the early
stage of use. Please check and adjust to the
appropriate tension frequently, because the
loose chain is easy to derail, which may lead to
rapid wear of the chain and guide plate.
2.
The chain must be stuck to the sprocket. After
installation, please check it again.
