Fig.24
Fig.25
1
O N
O F F
1 1
PRUNER INSTRUCTIONS MANUAL
3)
An oil different to that recommended could
cause damage to the bar, to the chain and to
the lubrication system.
6.
REFUELLING
(refer to Brushcutter manual. The same
conditions apply).
BELT HOOK AND FIXING RING (Fig. 11)
(refer to Brush Cutter manual. The same
conditions apply).
7.
STARTING AND STOPPING
CAUTION! Do not start the motor
without first of all correctly installing
the Pruner Attachment (see
paragraph 4 Fitting) (refer to Brush
cutter manual. Same conditions
apply)
STARTING THE ENGINE
1)
Position the hedge trimmer in a safe starting
position.
2)
Rest the motor on the ground and arrange
the equipment so that the chain does not touch
the ground or any other object (we suggest rest-
ing it on a trunk, a piece of wood or on a raised
part of the ground) see fig.12.
3)
Remove the chain guard.
4)
Get into a stable position.
5)
With the left hand, push hard the equipment
on the ground.
6)
Do not rest the foot or the knee onto the shaft.
7)
Start the engine as shown in the Brush
Cutter manual (fig. 24).
IMPORTANT - HAZARD !! The
engine starts and remains half
accelerated and so the chain is
moving. Leave the motor to run for a few
seconds for heating.
Operate the trigger once to run the motor at
minimum and then stop the cutting chain.
IMPORTANT - HAZARD !! If the chain
does not stop at minimum motor
speed, contact an after-sales center
(refer to Brushcutter manual).
STOPPING THE ENGINE
1)
To stop the engine, move the switch (fig. 25
item 1) to the “OFF” position.
Summary of Contents for PBT3446TP
