10
PRUNER INSTRUCTIONS MANUAL
B10.1 –
The THROTTLE TRIGGER
LOCKOUT (see Brush Cutter
manual) stops accidental operation
of the throttle control lever.
B10.2 -
Engine power ON/OFF
SWITCH
(see Brush Cutter
manual).
DANGER!
The cutting device
continues to spin for a while even
after the on/off switch has been
turned to the
OFF
position.
Hold both handles firmly until the
cutting device has come to a com-
plete stop. See section
STARTING
AND STOPPING.
3. DESCRIPTION OF
MACHINE PARTS FIG.1
1)
Chain lubrication oil tank
2)
Chain guide bar
3)
Chain
4)
Bar cover
5)
Bar block cover
6)
Chain tightening screw
7)
Chain oil tank cap
8)
Clamp on rod lock screw
9)
Rod lock screw
10)
Rod
11)
Bar fastening nut
4. ASSEMBLY
1)
The pack contains the Pruner Attachment
separately from its rod (see fig.2).
FITTING THE PRUNER ON THE SHAFT
1)
Fit the pruner attachment
(fig. 3 part 1) to the
lower drive rod (fig. 3 part 2) being careful to
correctly fit the drive shaft (fig. 3 part 3) in the
special housing in the gear box.
WARNING
The
locating hole (fig. 3 item A) on the shaft must
match the position of the gearbox hole (fig. 3
item B).
2)
Firstly fit and tighten the locating screw (fig. 4
item 1), then firmly tighten the clamp screw (fig.
4 item 2).
FITTING THE COMPLETE PRUNER
ATTACHMENT ON THE BRUSHUCUTTER
Make sure that the clamp locking knob (fig. 6
item 3) is slackened.
1)
Move the bottom drive shaft (fig. 6 item 2)
close to the upper drive shaft (fig. 6 item 1),
making sure the flexible peg (fig. 6 item 4)
matches the position of the bordered hole (fig. 6
item 4).
2)
Insert the bottom drive shaft onto the upper
drive shaft making sure the small flexible peg
(fig. 6 item 5) matches the position of the
bordered hole (fig. 6 item 4). See fig. 7.
3)
Firmly tighten the clamp screw knob (fig. 8
item 1) to ensure the two shafts are firmly and
safely connected.
4)
The equipment fitted with the motor is shown
in fig. 9
WARNING! Start the engine only after
connecting the bottom drive shaft to
the upper drive shaft. Make sure the
clamp screw knob (fig. 7 item 1) is firmly
tightened.
5. CHAIN OIL SUPPLY
1)
IMPORTANT!
Use only specific oil for
lubricate of power saw chains (see fig. 10).
2)
DO NOT
use old oils.
Summary of Contents for PBT3446TP
