7
The high-pressure cleaner is supplied with five
different nozzle types:
- Low-pressure nozzle (fig. 3A, “CHEMICAL”): for
operating with detergent or cleaning with negligible
pressure,
- 0° nozzle: straight stream (fig. 3B) for particularly
stubborn accumulation of grime,
- 15° nozzle: flat spray (fig. 3C) for dirt accumulation
over a large surface,
- 25° nozzle: flat spray (fig. 3D) for dirt accumulation
over a large surface,
- 40° nozzle: flat spray (fig. 3E) for dirt accumulation
over a large surface
.
fig. 3A fig. 3B fig. 3C fig. 3D
fig. 3E
IV. APPLIANCES PROVIDED WITH THERMAL VALVE
This device enables the machine’s by-pass operation
through automatic water discharge whenever it reaches
a temperature of nearly 60°C and cooling working
components.
•
CAUTION
: appliances that are not provided with
this disposal must not operate for more than 2
minutes with released gun. Recycled water raises its
temperature remarkably causing great damages to the
pump.
MONTAGE
Study the series of photos shown below (fig.4):
OPERATING INSTRUCTIONS
•
CAUTION!
Do not run the engine with a high or low
oil level as this can cause engine damage. If you have
further questions regarding the engine, please refer to
the engine’s operating manual included with the unit
.
•
CAUTION!
The engine is not provide with oil
. It is
necessary to fil the carter before starting the engine
.
•
CAUTION!
Before starting the pump, check the oil
level in the pump
.
•
CAUTION!
If it is the first time that you use the
machine or if you do not operate the machine for a long
period, it is necessary to connect, for some minutes, the
suction hose, in order to let possible impurities go out,
so that the nozzle gun will not become clogged
.
•
CAUTION!
Fill gas tank with unleaded gasoline. Do
not use leaded gasoline
.
I. STARTING UP
WATER SUPPLY
Water supply connection - Additional safety infor-
mation
WARNING:
(symbol) machine not suitable
for connection to the potable water mains.
•
CAUTION
:
Water that has flown through backflow
preventers is considered to be nonpotable.
•
Caution - Danger!
Only clean or filtered water should be used for intake.
The water intake should be at least twice the pump ca-
pacity.
- Minimum delivery rate: 15 l/min
- Maximum intake water temperature: 40°C
- Max inlet water pressure: 1Mpa
Place the cleaner as close as possible to the water sup-
ply.
Water supply from the water main
•
Connect a supply hose (not included) to the water
inlet of the unit and to the water supply.
fig. 4
2x
4x
