![background image](http://html1.mh-extra.com/html/lavor/independent-2000/independent-2000_manual_4061801017.webp)
17
anti-action, and then make
a
rapid pull.
•
CAUTION: Return the starting rope handle gently to
prevent damage to the starter.
9. Preheat the engine and push back the choke lever to
“OPEN” (Fig.14).
Choke lever
fig. 14
OPEN
•
CAUTION: Do not allow pressure washer to idle for
more than 2 minutes without switching off. Failure to
do this could cause appliance to the malfunction.
II. STOP
In an emergency, push the engine switch to “OFF”
to stall the engine. Stop it in normal in the following
sequence:
1. Push the engine switch to the OFF position (Fig. 15).
fig. 15
OFF
2. Set the fuel cock to the OFF position (Fig. 16).
Engine switch
fig. 16
OFF
•
CAUTION: Turn off the machine when finished
working.
•
CAUTION: When the machine is switched off, always
discharge the pressure hose, opening the gun.
MAINTENANCE
•
CAUTION: Before to carry out any kind of maintenance
to the washer machine, run the pressure down, take the
water connection out.
I. LUBRICATION
Motor: see “owner’s manual - general gasoline
engine”.
High-pressure water pump: we recommend GEAR
SYNTHETIC OIL ISO 150 - Oil capacity 60 gr.
II. WATER SUCTION FILTER CHECKING
Check periodically in order to avoid deposits clogging
it (fig. 17).
fig. 17
III. LONG STORAGE PERIOD
If you forsee/expect to keep the machine in
environments where there is danger of ice/frost or if
you don’t use it for more than 3 months, we suggest to
get the machine to intake an antifreeze before putting
it away (similar to that used for cars).
Furthermore, at start-up, small leaks may occur from
the pump; these will disappear after a few hours in
operation. Up to 10 drops a minute are acceptable;
in case of larger leaks contact an Authorised Service
Centre.
TROUBLESHOOTING
Motor: see “owner’s manual - general gasoline
engine”.
High-pressure water pump: