LAVAZZA CLASSY PRO, Instructions Manual

Page: 18 / 106

18
EN
PROGRAMMING
DOSE PROGRAMMING FOR
MACCHIATO, CAPPUCCINO AND
LATTE
Measures are always programmed using the same
key, any other keys are ignored.
The programmed amount of milk, foam and cof-
fee supplied (min. 0,6 oz / 20 ml) can be modi-
fied by repeating programming.
Should a coffee dose lower than 0,6 oz (20 ml) be
set, the coffee machine will store in any case the
minimum coffee dose that can be set.
Press the On/Stand-by button to switch the
machine on. The machine will be ready when
the On/Stand-by button stops blinking and
the supply button lights are ON steadily.
Lift the pod loading lever until it locks into posi-
tion to open the pod fitting compartment.
Put a Lavazza Blue or Expert capsule into the
capsule fitting compartment.
Place the bottle containing the milk near the
machine.
Insert the milk tube into the bottle.
Press and hold one of the three beverage deliv-
ery / / for at least 5 seconds.
The selected button will flash and the coffee
machine will enter the programming mode.
Now release the key.
During programming, the display shows the ani-
mation of the selected beverage.
Programming allows you to set the dosing of
each component of the beverage: milk, foam
and coffee. The beverage component which is
being programmed (milk, foam and coffee) is
highlighted in the display animation.
If the programmed measure exceeds the maximum
allowed (8 us fl. oz.) the machine will automatically
stop delivery, the delivery button will blink and the
last programmed measure will be saved in the
memory.
The machine will dispense milk, foam and cof-
fee in sequence. After reaching the required
amount of the programmed beverage, stop
supply by pressing again the previously used
button
.
Once programming is over, lift and then lower
the capsule loading lever to unload the exhaust-
ed capsule.
Wait for supply buttons and multifunction
button turning on with steady white light.
Macchiato