Safety
& Accessory
Initial Use
Diagnostics
FAQ & Care
Product Profile
54
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
A. For LAUNCH Wi-Fi mini printer, follow the steps below to connect the printer.
1. Tap
Printer Set
.
A. If it is the first time you have operated this printer, please proceed the following:
2. For initial use, you are suggested to reset the printer: Press and hold [MODE] & [FEED] for 8 seconds,
the following resetting command will be printed out:
at + default = 1
ok
at + reboot = 1
rebooting...
3. Tap
Reset
to configure Wi-Fi printer.
Step 1: Connect the printer:
Tap
Scan
to start scanning and select the desired printer hotspot named with X-431PrINTEr-XXXX
(XXXX stands for 4 characters), and then tap
Connect
to enter Step 2.
Step 2: Join the Wi-Fi printer into LAN:
Tap
Scan
to select the desired local Wi-Fi network from the list, and type in the security password (If it is
an open network, password is not required), and then tap
Confirm
.
4. Once the Wi-Fi network of the printer is connected and the printer is found, tap
Printing test
to test the
printing.
Now you can use the Wi-Fi printer to print!
If the printer is not found, please reset the printer to default factory settings (refer to Step 2 for details) and
check whether the current device and the printer are on the same LAN.
B. If you have configured the Wi-Fi printer to the LAN:
2. Tap
Connect to Printer
:
a). If the local network remains as it is, tap
Test Print
directly to test the printing.
b). If the local network changes, you have to reset the Wi-Fi printer.
B. For other Wi-Fi printers,
Before printing, make sure the following conditions are met:
• The Wi-Fi printer is powered on and working normally.
• The print service plug-in associated with the printer is already installed on the tablet (go to google Play
or use the Browser to download and install it).
Follow the steps below to proceed:
1. Set the default printer as System.
2. Go to
Settings -> Network & Internet -> Wi-Fi
, set the WLAN switch to Off.
3. On the report/data stream details page, tap
.
