Safety
& Accessory
Initial Use
Diagnostics
FAQ & Care
Product Profile
43
www.x431.com +86 755 8455 7891
LAUNCH
PAD VII
User Manual
device, and the other end into the vehicle’s DLC port.
Note: During the SmartLink diagnosis, especially during remote online programming, it is recommended that
the vehicle battery is connected to a charging power source. Doing so can prevent the vehicle from running out
of power and failing to start due to long diagnosis time.
3. Plug one end of CAT-6 crossover cable into the LAN/WLAN port of the SmartLink C device, and the other
end into the LAN port of network modem.
Note: The network broadband of 100MB and above is required for this operation.
4. After a successful network connection, the SmartLink C screen displays prompt information asking
whether to enter the super remote diagnostic mode. Tap
Yes
, the system will automatically read the
vehicle information and connect to the remote diagnosis server.
Note: One SmartLink C can only accept one remote diagnostic operation at one time.
5. Turn on the vehicle ignition.
Note: After receiving the order, the SmartLink B master technician will accept the order and contact you via
phone or E-mail address.
6. After a successful connection between the SmartLink C and SmartLink B is established, the following
message will be displayed on the SmartLink C screen.
