LAUNCH CNC-603A Injector Cleaner & Tester User Manual
15
Figure 5.15 Line Connection 2
1-CNC-603A Injector Cleaner & Tester; 2-Engine; 3-Stopper; 4- Fuel-inlet hose to engine; 5-Fuel tank;
6-Fuel filter; 7- Engine fuel supply hose; 8-Fuel pump
；
5.6.3 Tidy up after on-vehicle cleaning
1)
After the on-vehicle cleaning is completed, turn off the ignition switch of the vehicle. Restitute the hose
connection, start the engine and accelerate properly to check if there is any fuel leakage at the connectors or
in the hoses.
2)
Please clean the fuel tank and the lines of the device with test solution at the end of the on-vehicle cleaning,
the specific procedures are: drain the detergent left in the fuel tank first and dispose it according to its
cleanliness. Add a small amount of test solution into the fuel tank, connect the fuel outlet hose of the device
to the oil return port and power on the device. Select “Leakage test” item and press [RUN] button to run the
device for about 2
3 minutes. After the running has stopped, drain the test solution from fuel tank and
dispose the drained liquid according to relevant regulations.
3)
Clean up the site and tidy up the washing machine for later use.
Note:
1)
When cleaning, care must be taken as the detergent is inflammable. Prepare at least one effective fire
extinguisher.
2)
Be sure that all lines are well connected and there is no leakage before performing cleaning.
5.7. Language Selection
To adapt to the needs of different countries, multiple languages are available. Users can choose the appropriate
language according to their needs.
Method and Steps:
1)
Move the cursor to the language selection icon on the main interface and press the knob to enter the
language selection interface, as shown in Figure 5.16.
2)
Turn the knob to select the corresponding language, as shown in Figure 5.17. Press the knob and the
system will automatically change the language and exit the language selection interface automatically.
Figure 5.16 Figure 5.17
5.8. Version Information
Select version information icon on the main interface, as shown in Figure 5.18, and press the knob to check
to 3 of fig. 5.14
