ID Function
Unit
Command
52 Control parameter TdE
[s]
OUT_PAR_07_XXXX.X
54 Correction limitation
[K]
OUT_PAR_09_XXX.X
56 Control parameter XpF
[–]
OUT_PAR_10_XX.X
60 Control parameter Prop_E
[K]
OUT_PAR_15_XXX
Table 28: Control
ID Function
Unit
Command
58 Set point offset
[K]
OUT_PAR_14_XXX.X
66 Control in control variable X: 0 = internal / 1 = external Pt /
2 = external analog / 3 = external serial / 5 = external Ethernet /
6 = external EtherCAT / 7 = external Pt 2 (only for Integral)
[–]
OUT_MODE_01_X
68 Offset source X for set point: 0 = normal / 1 = external Pt /
2 = external analog / 3 = external serial / 5 = external Ethernet /
6 = external EtherCAT / 7 = external Pt 2
[–]
OUT_MODE_04_X
Note (ID 66 and 68): If X = 3, the commands ID 66 and ID 68 cannot be executed in some constant temperature control
devices until an external temperature specification has been received (via the command ID 15).
Table 29: Rights
ID Function
Unit
Command
62 Master keyboard (equivalent to "KEY"): 0 = unlock / 1 = lock
[–]
OUT_MODE_00_X
64 Keyboard remote control unit (command): 0 = unlock / 1 = lock
[–]
OUT_MODE_03_X
Table 30: Status
ID Function
Unit
Command
74 Switch the device on / off (standby)
[–]
START / STOP
Table 31: Programmer
ID Function
Unit
Command
76 Select the program for the subsequent commands (X = 1 – 5). The
default program is 5 when the constant temperature equipment is
switched on.
Caution!
Executing this command may stop any programs that are currently
running.
[–]
RMP_SELECT_X
78 Start programmer
[–]
RMP_START
79 Pause programmer
[–]
RMP_PAUSE
V6
Integral Process Thermostats and High-Temperature Thermostats
60 / 198
