Lathem PC700, User Manual

Page: 32 / 52

28
•
Using the PC700 Series Clock
Relay Settings
This menu allows you to configure how the clock uses the on-board
relay.
To enter administrator mode at the clock press the Admin button.
The Enter PIN screen will display.
•
Using the numeric key pad enter the administrator PIN
number and press Enter.
•
The Administrator Main Menu screen will display.
•
Press Relay Settings. The Relay Setup screen will display.
•
Select the Mode.
o
Off - The relay is disabled.
o
Access - The relay will be used to activate a door strike
allowing employees to enter the facility.
o
Signal - The relay will open/close to sound the signaling
device.
•
The Schedule button will display if Signal is selected. Press
Schedule and enter the bell events. Up to 100 events can be
programmed.
•
Select the duration to for the relay. By default, it is set at 5
seconds.
•
Use the Test button to activate the on-board relay to test the
connection.
•
When finished press the back

button until you have
returned to the default screen.
See Appendix D for steps to add/edit/delete bell events.
Test Connection
This menu allows you to test the clocks connection to the internet
and PayClock Online.
To enter into administrator mode at the clock press the Admin
button. The Enter PIN screen will display.
•
Using the numeric key pad enter the administrator PIN
number and press Enter.
•
The Administrator Main Menu screen will display.