Lastec The Articulator 3696H, Owner'S Manual, Page: 59 / 86

Operating Procedures
Stopping The Engine
Operating Procedures Lastec//021819 4-3
4
engine. If the operator seat is not occupied, either steering control arm is not locked into
neutral position, or the parking brake is not in the ON position, you cannot start the
engine.
Activation of these switches is indicated by the operator present and neutral start lights on
the control panel (the two green lights directly above the key switch). Turn the key switch
clockwise to the RUN position. If both green indicator lights are activated, you are ready
to start the engine.
As with any diesel engine, you must first pre-heat the glow plugs under cold conditions
before attempting to start the engine. To do this:
1. Turn the key switch counter-clockwise to the GLOW position for 9 seconds. After 9 sec-
onds, the audible warning beeper will sound, signifying adequate preheat.
2. Turn the key switch clockwise to START position, cranking the engine for a maximum of
10 seconds.
NOTE: Cranking engine for more than 20 seconds will cause electrical failure!
3. If the engine does not start within 10 seconds, discontinue cranking by turning the key
switch counter-clockwise to the OFF position. Wait 60 seconds. Repeat steps 1 through
3. If, after several attempts, the engine will still not start, discontinue the starting process
until the cause of malfunction is determined.
4. When the engine starts, adjust the throttle lever (located to the lower right of the operator
seat, behind the right steering control arm) forward until the engine is running at a steady
idle. Do not overpower the engine.
4.2 Stopping The Engine
Stop the engine by throttling down to a slow idle, then turning the ignition key switch to the
OFF position. Wait for all motion to stop. Be sure all auxiliary switches are in the OFF
position. Set the parking brake before dismounting the Articulator.