1 Starter Kit
4 Lassen SQ GPS Receiver
1.2.1
Removing the Lassen SQ GPS Module
The Lassen SQ GPS module is secured to the motherboard with
double-sided adhesive tape allowing for easy removal and integration
with the user’s application. (The adhesive tape used by Trimble is 3M
Scotch, part number 4945).
Follow these steps to remove the module from the motherboard:
•
Unplug the I/O cable and the RF cable from the module.
•
Use a small flat-head screw driver to pry the Lassen SQ GPS
receiver module off the motherboard.
Warning – Once the Lassen SQ GPS receiver module is removed from
the motherboard, the double-sided tape looses some of it’s adhesive
quality. This adhesive tape may only be re-used for laboratory testing. The
original adhesive tape should not be re-used for drive testing the Starter
Kit interface unit because the module could loosen and cause short circuit
when contacting other motherboard components. If drive testing is
required, use a new piece of double-sided adhesive tape to re-attach the
Lassen SQ GPS receiver module to the motherboard.
Summary of Contents for SQ
