Laski LS 150 T, Operating Instructions Manual

Page: 26 / 48

26
- When loading materials and during operation of the chipper the attendant
should always stand in the attendant's place, see fig.
- Having turned the chipping device on wait for speed stabilization. With that
you may soever increase or reduce the tractor PTO shaft speed. For correct
chipping functions it is necessary if the tractor PTO shaft speed is 540
rpm(1000 rpm).
- Wooden chips can be gathered in bulk or into a container located on a towing
vehicle.
- While discharging into a container, pay your attention to ejecting to avoid
ejecting chips back out off the container.
- Before going to another working place it is necessary to turn the PTO shaft off
and wait for total stopping of the cardan shaft. Before going lift up the chipper
above the ground by means of the three-point hitch and tractor hydraulics.
- Do not load materials with parts of metal, glass, ceramics and other similar
objects.
- Do not chip or load materials while driving.
- Having put materials in the loading chute/between loading rolls, release the
loaded material immediately and keep a certain distance from the chute.
- When working, never lean over the loading chute and never pull out wooden
materials, already loaded, from the chute.
- Do not load materials with diameters exceeding 150 mm.
- If loaded materials are spreading with risks of catch holding of attendant's
dress being drawn in the loading chute then it is necessary to prepare such
materials accordingly (trimming, cutting).
- Pay special attention to thorny materials, such as acacia and roses, which may
easily catch your sleeves.