Laski LS 150 T, Operating Instructions Manual

Page: 13 / 48

13
Before transport on public roads:

Set the machine in the transport position, i.e. with its discharge duck tilted
backwards and locked against motion. Be aware that traffic lights must remain
visible.

Couple the chipper to a towing vehicle properly and check proper pin
coupling.

Plug and check traffic lights of the chipper.

If necessary, remove all mud, especially from tires, before coming to a public
road.
Transport on public roads

When going on roads the chipper must be lifted at least 25-30 cm above the
ground.

Any transport on public roads is allowed only with the PTO shaft turned off
and the discharge duck tilted.

Any transport of persons or of any load on the machine is not allowed.

Never exceed max. allowed transport speed.

While putting the coupled chipper aside block the tractor wheels against
unwilling motion by means of scotch blocks.

Pay attention to handling performance on roads. Cornering, turning, braking
make new demands on driving.

Adjust driving speed to ambient conditions, especially at turning, obstacle
crossing, exits to plots etc.

This machine is approved to transport on public roads. Some restrictions are
given in your registration papers. Take these papers always with you.

Before coupling to a tractor check up the allowed weight limit in the tractor
hitch and compare it with the weight of your chipper. If a load on the tractor
front axle is less than 20% total weight, any coupling to a tractor is forbidden.
Note: Be aware that traffic rules and regulations in different countries may differ.