25
-
Carry out a functional check of the safety frame of the loading chute. Set the
lever in the infeed position and the loading rolls start turning (loading). By
first pushing the frame the rolls should stop loading immediately
(EMERGENCY STOP), the next pushing behind the chute edge (D) brings
their reverse turning.
Legend:
A - loading chute, B - safety frame, C - attendant's place, D - loading chute edge,
E - infeed direction, G - control lever
-
The safety frame must be always adjusted so that the
EMERGENCY STOP must be activated before the point D –
loading chute edge.
-
Do not leave the machine unattended.
Chipping
-
The chipper is powered by a tractor combustion engine. Do not
start it in confined or ill-ventilated spaces or under conditions of
low visibility.
-
While chipping the chipper must always be properly coupled to a
tractor.
-
It is not allowed to use the cardan shaft with its damaged guard. This guard
must be properly locked against turning. Check up locks on the sliding shaft.
-
Set the discharge duct in required direction. The discharge duct cannot be
directed to the attendant's place, see following figure.
Summary of Contents for LS 150 T
