Manual: RTI NEO SIX RGB 2
page 9 / 30
131 - 140
Triangle with grating
141 - 150
Line horizontal with grating
151 - 160
Line vertical with grating
161 - 170
2 dots horizontal with grating
171 - 180
2 dots vertical with grating
181 - 190
3 dots horizontal with grating
191 - 200
3 dots vertical with grating
201 - 210
Circle with grating
211 - 220
4 quarter circle with grating
221 - 230
Test picture with grating
231 - 240
1 dot with grating
241 - 255
Blackout
9 Zoom
0 - 255
Gobo size
active, if value
of channel 8
between 11
and 110
10 Strobe
0
Stobe off
Strobe effect
1 - 127
Strobe speed
2Hz - 12Hz
128 - 255
Grow effect
256 points - 0
points
3.
Interlock (RJ45 Interlock)
There are a ‚Interlock in‘ and a ‚Interlock out‘ (Interlock loop) interface on the rear side of
the device. The RJ45 interlock connector is provided for testing purposes. If the ‚Interlock
in‘ is plugged in the laser sources of the devices get enabled (if key switch is in ‚ON‘ posi-
tion). Always use the Interlock connector located on the left of the ‚DMX active‘ LED as an
input. ‚Interlock out‘ can be used as interlock loop to switch all connected devices simulta-
neously with only one E-Stop.
4.
Key Switch
There is a key switch on the rear side of the device. Please insert the key into the key
switch and turn it to ‚Laser on‘ position to enable laser output. Turn the key to ‚Laser off‘
to switch off the device. Please remove the key to avoid unauthorized access.
5.
Fuse
There is a fuse at the rear side of the device. If the fuse should blow, please change it by
a new 2.5AT fuse. If the problems recurs, please contact your dealer or the Laserworld
service department.
6.
Display / Settings at the device
It is possible to do settings directly at the device by means of the integrated 16 digit
display and the 5 buttons next to it:
