Manual: RTI NEO SIX RGB 2
page 11 / 30
By pressing the down button (arrow down) again the mode can be changed by using the
+ / - buttons.
In ‚normal‘ mode the device is in the hanging position or inverted as a floor stand:
In ‚inverted‘ mode the X and Y axis are inverted and the output channels are changed to
the inverted order 6 to1.
So the output channel 1 is always on the left side from the front direction of the device if
this option is chosen:
Advanced settings - Attention: For expert use only!
If the device needs to be reset, the middle button has to be pressed when powering up the
device. It enables access to advanced (main) settings.
By pressing the and the button - at the same time all previous saved settings are
deleted and the device is running factory settings now.
Be aware that you can easily destroy a diode when changing these settings!
Some green diodes can reach a maximum power of 120mW at 300mA, some only at
460mA. These ones using 300mA won‘t increase power if they are turned on to 460mA.
The diodes just get destroyed.
This setting should only be used by professionals, trained in Thd and Iop . All settings are
given in 16bit (0-65535).
The offset for red changes the threshold current flowing when the DMX value for red mo-
dulation becomes greater than 0. The possible value is limited to the range of 57600 –
59000. It changes the maximum Iop at the same time since the whole current frame will
be shifted up or down.
By pressing the middle button the channels can be switched from 1 to 6 depending on
what output needs to be changed: