Manual: RTI NEO SIX RGB 2
page 5 / 30
12. Ensure
sufficient ventilation
and do not
place the device on any warm or heat ra-
diating surface. Especially the
ventilati-
on openings must not be covered
!
13. Ensure that device does
not get over-
heated.
Make sure that the device is not
exposed to spotlights (especially moving
heads). Heat of spotlights could overheat
laser in a little while and leads to a degra-
dation of performance.
5. Service Notes
• Moisture and heat can reduce lifetime of
the laser system dramatically and expires
any warranty claim.
• Quick on/off switching of this device will
reduce durability of the laser diode dra-
matically.
• Avoid sharp knocks and shocks to this
device and ensure sufficient protection
during transportation. Look after your La-
serworld product.
• To increase durability of your laser,
protect device against overheating:
-
Always ensure sufficient ventilation.
-
Do not face spotlights (especially mo-
ving heads) to the device.
-
Check temperature after approx. 30
minutes with each new installation.
If necessary install the projector at a
place with different temperature.
-
Keep the device dry. Protect it from
moisture, rain and damp.
-
Switch off device when it is not nee-
ded. Diodes are switched on and can
wear out even if there is no visible la-
ser output.
•
Removal of the warranty label as well
as damages to the device caused by
improper handling, neglect of the sa-
fety instructions and service notes will
void the warranty.
4. Working on the Device
1. This product has no user serviceable parts inside and should only
be maintained and serviced by a qualified engineer.
2. Be sure that the mains plug is not connected to the power
supply while installing the device.
3. Take off all reflecting things like rings, watches etc. befo-
re starting to work with or at the projector.
4. Only use non-reflecting tools to work on device. Wear protec-
tive clothing (like goggles, gloves etc.) according to laser power and wave-
length of the laser.
